FLOOR

jig to hold the tabs in place for tacking	1/8" tabs for the diamond plate in the front formed tabs for the skid pan under the seats and the read portion of the cockpit 1/4" aluminum diamond plate for the front area 16 gauge flat steel for the skid pan under the seats (roll on Herculiner or similar to treat it and reduce vibration and seal the steel)	Plenty of support in the front for the Diamond plate
"the bell rang Dustin!" "almost done MRC, one more tab..."	good templates make the job easy that and a carbide tip Circular saw blade!	...like a glove
1 plate drilled, the rear pan fitted and marked. will be drilled or punched for drainage	DUSTIN and ED drop in the front plates and bolt them in with 5/16 carriage bolts	Rear Floor pan ready for install 16 gauge flat steel-to be Herculined
Casey and Ed welding out the bottoms of the Floor tabs	diamond plate inset with controls set on top	rear pan bolted in place then quickly covered with the seats