CHASSIS

Up BUILD TEAM LIVE BUILD CAM CHASSIS MOCK UP FEB 7 FEB 21 WALKAROUND ROLLING CHASSIS APRIL 11 LATE MAY JUNE REASSEMBLY REASSEMBLY II FINAL Assembly ACTION HORSFALL 08 JULY 30 CONTROLS FLOOR WHEELS-TIRES TRANS CONVERSION DRIVETRAIN FOA Shocks ELECTRICAL ENGINE 1 ENGINE 2 COOLING FUEL CELL EXHAUST ENGINE PULL FRONT END REAR HUB REAR SUSPENSION SEATS ACCESSORIES COLORS PARTS LIST Columbia HS Visit BUILD TEMPLATE

Chassis fabricated by ASAP Fabrication in The Dalles, OR
  • Chassis design Jack WIll-ASAP
  • .120 wall steel 1.5" tube
  • .098 wall steel 1" tube
  • 10 degree front camber
  • hoops for front shocks
  • rear hoop to support 4.3V-6
  • Bus trans mount
  • Chassis welded to 6" wider warrior beam
  • Delivered Dec 13
  • Received from PPC July 9(see below)

NOW the fun can REALLY BEGIN!


BOB lowering the chassis from the rafters for Ed and Casey

Rear hoop for Motor support
Coffee cup in picture for "scale"

Fabrication progress


 
AND.. here is how it turned out after Portland Powder Coating was done with it

with the help of PRO-TOOLS the honker shop builders will be able to create quality bends for tubing on the rear chassis and accessories

 

HPM 200 with 1 and 1.5" tubing dies
 
bullet Completely portable move to any location,
no electric or air needed
 
bullet Make accurate smooth bends without
kinking, wrinkling, or crushing
 
bullet Heavy duty friction free roller
 
bullet 20 Ton hydraulic cylinder  
 

http://www.pro-tools.com/200.htm

Back to the SHOP pages

www.honkernet.net/ahs

last modified 07/21/2010

BY MRC