dimensions of the plan are similar to project WILDSIDE.

Each piece identified so it can be bent to order

model may be spun 3-D

BendTech Pro Software with the
help of ASAP FABRICATION

• the Honker crew designed the chassis
  in the BT program and ASAP FAB is
  helping us make it AS WE DESIGNED
  with some fab techniques from years
  of experience using our Protools One
  Shot bender and their ProBend 105
  for the angles over 120 degrees.

• Trusting the computer is
  HARD but rewarding

BR tells you how long to cut the tube and
 where to START each bend

measurements are lined up on each tube before the sequence
of bending begins (most tubes have 2 or less bends)

curtis bending the long side front tube

upper hoop for the roll cage

imagine a floor.. 20 inches below. 

bending the nose at 120 degrees

Manual rotary bender with a long cheater

YES.. it fits.. just like the BT software said!